Hardware Installation

Before configuring your ATA, please see the procedure below for instructions on
connecting the device in your network.

1. Connect analog phone to FXS Port with a RJ11 cable.
2. Connect the WAN port to your ISP’s ATA/switch with a RJ45 cable.
3. Connect one end of the power cord to the power port of the device. Connect the other end to the wall outlet.
4. Check the device LED to confirm network connectivity.

Warning

Please do not attempt to unsupported power adapters and do not
remove power during configuring or updating the device. Using other
power adapters may damage the device and will void the manufacturer
warranty.

Changes or modifications not expressly approved by the party
responsible for compliance can void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency cause harmful interference to radio communications. However, there is no energy and, if not installed and used in accordance with the instructions, may guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.